• Typical Application: Pneumatic instrumentation circuits, lubricant and cooling lines.
• Pressure: Working pressure up to 500 psi with a 4:1 safety factor depending on tube size.
• Vibration: Excellent resistance.
• Temperature Range: Depends on tubing used. –65°F to +250°F with brass sleeve, –40°F to +150°F with plastic sleeve. (Refer to tubing temperature range.)
• Material: CA360 Brass body, plastic sleeve.
• Used With: Aluminum, copper and hard plastic tubing requires brass sleeve. Weatherhead PT200 and PT240 plastic tubing use plastic sleeve. Not recommended for steel tubing.
• Advantages: No flaring of tubing required. Easy installation, captive sleeve, preassembled for installation and can be reassembled.
• Note: 1/8” and 3/16” tube O.D. assemblies are supplied with brass sleeves and no inserts.
• Assembly Instructions:
1. Cut tubing to desired length.
2. Slide nut/sleeve assembly on tube.
Threaded end “A” of nut must face toward fitting.
3. Bottom tubing into fitting.
4. Plastic sleeve—tighten nut, hand tight. Brass sleeve— tighten nut, hand tight, then additional 3/4 turn.
Label Set: FS-2100 (adhesive) CL-498 (non-adhesive)