Danfoss (Weatherhead)

Compression Brass Female Connector

• Typical Application: Instrumentation, hydraulic and pneumatic systems.
• Pressure: Working pressure up to 2000 psi with a 4:1 safety factor depending on tube size.
* Vibration: Fair resistance – use long nut when greater vibration resistance is needed.
* Temperature Range: –65°F to +250°F (–53°C to +121°C) range at maximum operating pressures. (Refer to tubing temperature range.)
• Material: CA360 Brass.
• Used With: Aluminum, copper and Weatherhead plastic tubing.
• Advantages: Low cost. Easy to assemble, no flaring. Available with long or short nut. Broad selection of styles and sizes.
• Conformance: Listed by Underwriter’s Laboratories (available on special order) for flammable liquid. Meets specifications and standards of ASA, ASME, SAE.
Label Set: 
W-8022 (adhesive) 
CL-490 (non-adhesive)

Part Number
TUBE O.D.
OKCancelClear All
FEMALE PIPE THREAD
OKCancelClear All
HEX
OKCancelClear All
I.D.
OKCancelClear All
66X2
1/8
1/8
9/16
.094
66X3
3/16
1/8
9/16
.125
66X4
1/4
1/8
9/16
.188
66X4X4
1/4
1/4
11/16
.188
66X5
5/16
1/8
9/16
.250
66X5X41
5/16
1/4
11/16
.250
66X6X2
3/8
1/8
9/16
.312
66X6
3/8
1/4
11/16
.312
66X8
1/2
3/8
13/16
.406

Ref. SAE No. 060103BA

1. Cut tubing to desired length. 
2. Slide nut and then sleeve on tube. Threaded end “A” of nut must face toward fitting. 
3. Insert tubing into fitting body. Be sure tubing is bottomed on fitting shoulder. 
4. Lubricate threads and assemble to fitting body. 
5. Tighten nut hand tight. From that point, tighten with a wrench the number of turns indicated in the chart below.