Danfoss (Weatherhead)

SAE 45° Flare Brass Male Run Tee

Typical Application LP and natural gas, flammable liquids, instrumentation, refrigeration, power steering, hydraulic and pneumatic systems. 

Pressure: Working pressure up to 2000 psi depending on tube size. 
Vibration Good resistance – use long nut when greater vibration resistance is required. * Temperature Range: –65°F to +250°F range at maximum operating pressures. • Material CA360 Brass. 
Used With: Copper, brass, aluminum and steel hydraulic tubing that can be flared.  Advantages: Low cost and reusability, long or short nut. Good resistance to vibration.  Conformance: Listed by Underwriter’s Laboratories (available on special order) for flammable liquids, refrigeration and gas. Meets specifications and standards of ASA, ASME, SAE and MS (Military Standards). 
*Note: Refer to current price list for availability of cataloged items. Configurations and dimensions subject to change without notice. Quotations of non-stock items available upon request. Additional information can be found in SAE J512.

Part Number
TUBE O.D.
OKCancelClear All
MALE PIPE THREAD
OKCancelClear All
I.D.
OKCancelClear All
51X4
1/4
1/8
.188
51X8X8X8
1/2
1/2
.406
51X10
5/8
1/2
.500

Ref. SAE No. 010424

Assembly Instructions
 1. Cut tubing to desired length. Make sure all burrs are removed and ends are cut square.
 2. Slide nut on tube. Threaded end “A” of nut must face out.
 3. Flare end of tube with a 45° flaring tool.
a. Measure flare diameter.
b. Examine flare for excessive thin out.
 4. Lubricate threads and assemble to fitting body. Nut should be turned hand tight.
 5. Tighten assembly with wrench until a solid feeling is encountered. From that point, apply a one-sixth turn.

Label Set: W-8022 (adhesive)
CL-490 (non-adhesive)